By fusing the stabilizer to the back of the garment, the fabric will not move or stretch leading to better registration. The stabilizer is temporarily attached to the entire area where the embroidery will be stitched eliminates the use of messy spray adhesives which only "spot" tack and allow shifting of the fabric and are quite messy leaving residue on needles hoops and machine parts

We use a low melt fusible - 260 F so as not to scorch or shrink your fabric.

When you are finished with your embroidery, re-fuse the edges- peel back and trim around your design.

One layer should support 10-12,000 stitches of a moderately dense design. If you sandwich a tearaway behind it, it should hold a lot more!

Use the fusible version to cover up scratchy stitches on the back of the embroidery.

"I used the diagonal fusible mesh today and it was superb!!! It was so soft and was easier to trim the excess off the shirt when I was finished"
Karen Torluemke
K 'N ME Designs

Precuts for Diagonal Mesh Fusible are sold in packages of 250 pieces. This item is available in the following precut size: