HOLDS MORE STITCHES!
No Show "Diagonal" mesh is a nylon mesh stabilizer with a diagonal embossing pattern. It is more multi-directionally stable than previous versions. Therefore it will hold more stitches per single layer than the regular perpendicular patterned mesh leading to better and tighter registration or definition per single layer. If you add a mid weight tearaway as a sandwich it can hold an even higher stitch count!
It is perfect for left chest logos, pique knits, T Shirts, infant items and micro fiber apparel.
Also available in a FUSIBLE version!
By fusing the stabilizer to the back of the garment, the fabric will
not move or stretch leading to better registration. The stabilizer is
temporarily attached to the entire area where the embroidery will be
stitched eliminates the use of messy spray adhesives which only "spot"
tack and allow shifting of the fabric and are quite messy leaving residue
on needles hoops and machine parts
We use a low melt fusible - 260 F so as not to scorch or shrink your
When you are finished with your embroidery, re-fuse the edges- peel
back and trim around your design.
One layer should support 10-12,000 stitches of a moderately dense design.
Use the fusible version to cover up scratchy stitches on the back of the embroidery.
How to use No Show Diagonal Mesh:
How to use No Show Diagonal Mesh Fusible:
1. Cut a piece of the stabilizer at least one inch larger than the
Looking for more stabilizers and backings click here.
Looking for other embroidery supplies click here.